AnakSistemInformasiD3.com: 6.4.3.3 Packet Tracer

1. Open Packet Tracer 6.4.3.3 – Connect a router to a LAN. Click a device and then click the CLI tab to access the command line directly.

2. Enter. The console password is cisco. The privileged EXEC password is class.

3. Configure the GigabitEthernet 0/0 interface on R1.

Enter the following commands to address and activate the GigabitEthernet 0/0 interface on R1:

4. It is good practice to configure a description for each interface to help document the network information. Configure an interface description indicating to which device it is connected.

5. R1 should now be able to ping PC1.

6. Configure the GigabitEthernet 0/1 interface on R1.

Enter the following commands to address and activate the GigabitEthernet 0/0 interface on R1:

7. It is good practice to configure a description for each interface to help document the network information. Configure an interface description indicating to which device it is connected.

8. R1 should now be able to ping PC1.

9. R1# copy running-config startup-config

Configure the remaining Gigabit Ethernet Interfaces on R1 and R2.

10. R2 Click a device and then click the CLI tab to access the command line directly.

11. The console password is cisco. The privileged EXEC password is class.

12. Enter the following commands to address and activate the GigabitEthernet 0/0 interface on R2:

13. It is good practice to configure a description for each interface to help document the network information. Configure an interface description indicating to which device it is connected.

14. R2 should now be able to ping PC1.

15. Configure the GigabitEthernet 0/1 interface on R2.

16. It is good practice to configure a description for each interface to help document the network information. Configure an interface description indicating to which device it is connected. R2 should now be able to ping PC1.